IC695CMM002 RX3i - 2 Ch Serial Communications Module

GE - Emerson Automation
SKU:
IC695CMM002
$1,297.95 (Inc. GST)
$1,179.95 (Ex. GST)
Condition:
New
Current Stock:
Minimum Purchase:
1 unit
Adding to cart… The item has been added

PACSystems RX3i Serial Communications modules expand the serial communications capabilities of an RX3i system.
Serial Communications module IC695CMM002 provides two independent, isolated serial ports. Serial Communications module
IC695CMM004 provides four independent, isolated serial ports. Up to six Serial Communications modules can be located in the main PACSystems RX3i backplane. Each port can be configured for MODBUS Master, MODBUS Slave,
CCM Slave, DNP3 Master, DNP3 Slave, or Serial I/O protocol. In addition, for modules that that have firmware version 1.10 or later, each port can be configured for CCM Slave protocol. For modules that have version 1.20 or later, each port can be configured for DNP3 Master or DNP3 Slave protocol using Machine Edition 5.6 SIM 10 or later. If any port is configured for DNP3 Master or Slave, the other ports on the module can only be configured for DNP3 Master or Slave.
For modules with firmware version 1.32 or later, half-duplex flow control can be configured. Otherwise, flow control defaults to full-duplex.
Additional module features include:
▪ Port-to-port isolation and port-to-backplane isolation.
▪ RS-232, RS-485/422 communication, software-selected
▪ Hardware handshake: RTS/CTS for RS-232
▪ Selectable Baud Rates: 1200, 2400, 4800, 9600, 19.2K, 38.4K, 57.6K, 115.2K
▪ Module fault status reporting (Watchdog, Ram Fail, Flash Fail)
▪ Module identity and status reporting, including LED status indicators
▪ Meets CE, UL/CUL 508 and 1604, and ATEX requirements
▪ Flash memory for future upgrades
These modules must be located in an RX3i Universal Backplane. An RX3i CPU with firmware version 3.83 or later is required. Machine Edition 5.5 with Service Pack 2 SIM 4 or later is required for configuration. Machine Edition 5.6 SIM 6 or later is required for CCM Slave protocol. Machine Edition 5.6 SIM10 or later is required for DNP3 protocol. Machine Edition 5.8 SIM 2 or later is required for SPL protocol.
RX3i Serial Communications Modules can be hot-inserted and removed following the instructions in the PACSystems RX3i System Manual, GFK-2314.

 

MORE INFORMATION

Technical Data

Package Seal Opened:
Package Seal Opened